3000W 9000W Pure Sine Wave Power Frequency Inverter Board 24V 36V 48V 4000W 5000W High Quality Enough Power Perfect Protection

Description

NOTE：This product only is an inverter, other transformers need to be purchased separately!

input voltage : DC12V/24V/36V/48V/60V/72V/96V

output voltage : AC220V

output power : 1500W/3000W/4000W/5000W/6000W/7500W/9000W

output frequency : 50Hz/60Hz 'adjustable'

Motherboard size: 240mm * 100mm * 65mm

Motherboard weight: about 0.82KG

2.Transistors

12V 24V use HY1906

36V 48V use RIFB4710

60V use RIFB4710

72V use HY3215 HY3312

96V use HY1920

3.transformer

12V–use 6.5V to 220V transformer

24V–use 13V to 220V transformer

48V–use 26V to 220V transformer

36V–use 19V to 220V transformer

60V–use 32V to 220V transformer

72V–use 39V to 220V transformer

96V–use 52V to 220V transformer

4.Features

1.enough power

2.pure sine wave

3.circuit is high efficient and stable

4.small no-load current

5.the battery has undervoltage / overload / overheat protection

6.Simple installation

7.work with all kinds of power frequency transformers

5.Protection

1. Battery low voltage protection:

When

the battery voltage is lower than 10.5V per node, the inverter will

turn off the inverter (there is no AC voltage output) and the inverter

is in standby mode.

2. Battery over-voltage protection:

When the battery voltage is higher than 15V, the inverter will turn off the inverter and enter the standby mode.

3. The battery starts automatically:

When the battery is under-voltage protection, when the solar or wind energy

charges the battery up to 13V per section, the inverter automatically

starts to output the AC voltage to power the load. Battery overvoltage

protection After the overvoltage protection and then restored to 15V per

section, the inverter also starts automatically.

4. Temperature control fan and over-temperature protection:

Fan

does not work during normal inverter operation, when the temperature is

too high, the fan automatically runs, when the temperature drops, the

fan automatically stops running. When the fan is damaged and the

temperature is too high, the inverter will turn off the inverter and

enter the standby mode.

When the temperature drops, it will automatically start the inverter and output AC power.

5 impact and short circuit protection:

The inverter has real-time hardware by wave current limit protection, and

software delay (400mS) short-circuit protection plus power frequency

isolation transformer. Improves the impact resistance of the product The

reliability of the product.

6.Driver board

The default setting of the driver board jumper is JP5, P2, JP7, JP8 short

circuit, the corresponding function is 50Hz, 3S soft start, dead time

300ns,

Note: The same function jumper cannot be shorted at the same time!! If JP1 cannot be shorted with JP5 at the same time.

LED to determine the type of fault

1. Normal: always bright

2. Overcurrent: blink twice, off two seconds, has been circulating

3. Overvoltage: blinking three times, off two seconds, has been cycling

4. Undervoltage: blinking four times, off two seconds, has been circulating

7.Note

1.Dear customer , if you have any technical problems , pls contact with

customer service , we have specialist . thank you !Before shipment, we

have debugged, please rest assured to buy and use.

2.This link only has an inverter, other transformers need to be purchased separately.

8.Package List：

1pcs pure sine wave power frequency inverter board